Skip to content

Adding a datasource for MindConnect IoT2040

To receive the data of your MindConnect IoT2040 you need to add a datasource. The datasource specifies the protocol and reading cycle that is used to transfer the data from your asset to the MindConnect IoT2040. Within the datasource, you enter the address of the asset inside of your network.

Requirement

  • You have created an asset and an aspect.
  • You have enabled the connection to the MindConnect IoT2040.
  • You have the IP address of the asset inside of your network.

Procedure

To add a datasource to an asset of type MindConnect, follow these steps:

  1. Select the Asset in the "Assets" tab.
  2. Click the asset icon, for example: "MindConnect IoT2040".
  3. In the Data Configuration view, click "Add New Datasource" and select the datasource to add a new datasource.

    add-new-datasource-iot2040

Note

  • The default reading cycle is 86400 seconds, which is one day.
  • You can find additional information on supported protocols in the chapter Configuring protocols.

4.Enter the datasource parameters.
add-new-source-1

5.Click "Save".

Result

You have now created a new datasource. The new datasource is available at the asset details of your MindConnect IoT2040.

The following graphic shows the datasource added:

added-data-source-iot2040

Cloning of Datasource

Clone of datasource creates a copy of datasource (including copy of datapoints). User needs to provide new name for datasource.


Last update: April 15, 2024